XP-240 won't enter recovery mode.

[AJs 0]

So I'm pressing the stop, colour copy, wifi and power button and..... it turns on like normal.

But it just won't enter recovery mode so I can install the new firmware.

I've watched you tube videos, spent an hour Googling and all instructions seem to fail.  

Is there something I'm doing wrong?

[Admin 17]

Hi! Please try this new file for you.

https://inkchip.net/download/INKCHIP.net_Firmware_99_XP240_v1.rar

1) Upload firmware which I sent

2) Switch on in normal mode(!!!!) just turn on button . - dont put printer in Program Update mode. (no need to press few buttons while turn on the printer)

The uploading process will stuck at 70-80% - it is ok!

Open task manager and stop updater process.

Printer will blink for about 5-15 minutes - then will power OFF.

Now power on the printer - chipless firmware is installed in your printer!

[AJs 0]

[Admin 17]

Your original firmware cannot be downgraded to earlier versions, and our chipless firmware is an earlier version.

Basic concepts of the solution:
- Standard InkChip firmware. Chipless firmware, which must be loaded into the printer using Firmware Mode.
- 99 InkChip firmware. Chipless firmware, which must be loaded into Normal Mode.
- Firmware Mode - special mode for updating printer firmware, which is activated when a certain key combination is pressed.
- Normal Mode - normal mode of operation of the printer, simple switching on the printer with the power button.

Algorithm for solving the problem:
1. Check and memorize the firmware version of the printer. The firmware version displayed is the original non-update version.
2. Flash printer 99 with InkChip firmware in Firmware Mode.
3. When trying to activate the firmware with the Activation program and the activation code, the program will generate the Reading failed 1.
4. Start flashing the printer 99 again with InkChip firmware in Firmware Mode. When the firmware status in Firmware Mode reaches 100%, and the printer display finishes counting the percentage of the firmware status, you need to pull out the power cable of the printer.
5. Connect the power cable and turn on the printer. Recovery Mode will appear on the display.
6. Flash the printer with Inkchip firmware in Recovery Mode.
7. Check the firmware version of the printer. The firmware version displayed must be different from the non-renewable firmware version. This version is the chipless firmware version of InkChip.
8. Activate chipless firmware with the Activation program.

This is just an example of a process. It doesn't matter what model of printer you have. This video is in Russian, but you can turn on English subtitles : https://www.youtube.com/watch?v=Duyj-UHbzxE

And after that just ran again the inkchip firmware upload in normal mode.

https://inkchip.net/download/INKCHIP.net_Firmware_99_XP240_v1.rar

[AJs 0]

Does that mean I have to buy the WIC?

This is incredibly complicated.  It's  taken 2 days so far.  And, unfortunately, your instructions aren't very clear for a novice like myself.  

2. What is 'Firmware mode'?  5. There is no display on my printer.   The video captions in English don't make a lot of sense.

And how long do I have to use my activation key?1

[Admin 17]

Hi!
You do not need to buy a WIC.
Entering firmware mode for your model is described in the instructions on the website (using a few buttons).
Also the keys have no expiration date.