Jump to content

Recommended Posts

I have a Mac Book Air M1 with Parallel Desktop with Windows 11 on it. I purchased the Chip less firmware for my Epson XP-15000 and it is connected both via network and USB cable to the computer. I install the firmware and it never shows up on step 5 there is no printer listed.. I have tried uninstalling printers, re-installng printers and I am not sure what I am supposed to be doing. I think under configure it is being shared to the mac and the windows but not sure what's wrong??? I can tell you I have been doing this for 8 hours and I am frustrated at this firmware 

Share this post


Link to post
Share on other sites

Hello!

This might be because there are too many printers on “Devices and printers” menu. That’s what might help you: turn off your printer, go to PC and remove all printers that may be in "Devices and Printers" menu, then turn your printer on, then open the software again and it might appear normally.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...