Downgraded(it cannot be updated)

[EMUzing 0]

launching inkchip firmware  it finds printer then dont let me checkmark the box it says Downgraded(it cannot be updated)  currently running 10.58.LQ29M3

[Admin 16]

14 hours ago, EMUzing said:

launching inkchip firmware  it finds printer then dont let me checkmark the box it says Downgraded(it cannot be updated)  currently running 10.58.LQ29M3

Hello! 
You should install 99 firmware in Recovery Mode.

[EMUzing 0]

What is the best way to get into recovery mode as I've tried via holding the power and the right corner of the display till it says update mode but that's not the correct way..

[Admin 16]

Could you please tell me your printer model?

[EMUzing 0]

Epson WF-2860 

firmware 10.58.LQ29M3

 

thnx

[EMUzing 0]

Tryed holding power and top right corner takes me to a update rom prompt

[Admin 16]

On 4/12/2023 at 6:52 PM, EMUzing said:

Tryed holding power and top right corner takes me to a update rom prompt

Your original firmware cannot be downgraded to earlier versions, and our chipless firmware is an earlier version.  

Basic concepts of the solution: 

- Standard InkChip firmware. 

Chipless firmware, which must be loaded into the printer using Firmware Mode. 

- 99 InkChip firmware. 

Chipless firmware, which must be loaded into Normal Mode. 

- Firmware Mode - special mode for updating printer firmware, which is activated when a certain buttons combination is pressed. 

- Normal Mode - normal mode of operation of the printer, simple switching on the printer with the power button.  

Algorithm for solving the problem: 

1. Check and memorize the firmware version of the printer. The firmware version displayed is the original non-update version. 

2. Flash printer 99 with InkChip firmware in Firmware Mode. 

3. When trying to activate the firmware with the Activation program and the activation code, the program will generate the Reading failed 1. 

4. Start flashing the printer 99 again with InkChip firmware in Firmware Mode. When the firmware status in Firmware Mode reaches 100%, and the printer display finishes counting the percentage of the firmware status, you need to pull out the power cable of the printer. 5. Connect the power cable and turn on the printer. Recovery Mode will appear on the display. 

6. Flash the printer with Inkchip firmware in Recovery Mode. 

7. Check the firmware version of the printer. The firmware version displayed must be different from the non-renewable firmware version. This version is the chipless firmware version of InkChip. 

8. Activate chipless firmware with the activator 

 

This is just an example of a process, it doesn't matter what model of printer you have. Please watch the video on our official YouTube channel: https://www.youtube.com/watch?v=h7qWYWjMNFQ  

 

And after that just ran again the inkchip firmware upload in normal mode.